RC hammers and bits are used in hole drilling in mines, hydrology and water well, geothermal well, geothermal air conditioning well, geologic exploration, gravel stratum, etc Especial suitable for complicated formation (Formation loose, difficult to drilling and unstable of hole wall), exhausting for deep hole, environment protection.
The drill cuttings travel around the inside of the cyclone until they fall through an opening at the bottom and are collected in a sample bag. For any drill hole there will be a large number of sample bags, each one marked to record the location and drilling depth that the sample was obtained.
The collected series of sample bag cuttings are later taken for analysis to determine the mineral composition of the drill hole. The analysis results of each individual bag represents the mineral composition at a particular sample point in the drill hole. Geologists can then survey the drilled ground analysis and make decisions about the value of the overall mineral deposit.
| TDS RC hammer Model | ||||||
| Hammer Model | Hole Range (mm) | External Diameter (mm) | Weight(without bit) mm | Bit shank | Working Pressure | Connection Thread |
| RC4108 | 115-130 | 108 | 78 | RE410 | 1.5-3.0 Mpa | REMET 3.1/2"-4" METZKE 3.1/2" |
| RC5116 | 120-135 | 116 | 85 | RE543 | 1.5-3.0 Mpa | REMET4" METZKE 4" |
| RC5121 | 136-133 | 121 | 73 | RE512 | 1.5-3.0 Mpa | REMET 4"-4.1/2" METZKE4"-4.1" |
| RC5126 | 140-152 | 126 | 95 | RE5126 | 1.5-3.0 Mpa | REMET 4.1/2" METZKE 4.1" |
| RC5130 | 140-146 | 130 | 82 | RE513 | 1.5-3.0 Mpa | REMET 4.1/2" METZKE 4.1" |